Do You Need to Make a Custom Fritzing Part?įritzing comes with tons of electronic parts already installed with the software. The awesome thing about Fritzing is that you can make your own Fritzing parts for your project and share with the community! This tutorial is going to go over how to make a custom Fritzing part in the Fritzing (New) Parts Editor, starting from the beginning. ESP-C3-32S support low-power Bluetooth:Bluetooth5,Bluetooth mesh. Bluetooth rate support:125Kbps,500Kbps,1Mbps,2Mbps. Support broadcast extension, multi-broadcasting, channel selection.Fritzing example of the INA169 connected to an Arduino The perfect security mechanism enables the chip to be perfectly applied to various encryption products. ESP-C3-32S has a variety of unique hardware safety mechanisms.The hardware encryption accelerator supports AES,SHA and RSA algorithm. Among them,RNG,HMAC and Digital Signature module provide more security features.Other security features include flash encryption and se-cure boot signature verification, etc.

ESP-C3-32S module provides a wealth of peripheral interfaces, including UART,PWM,SPI,I2S,I2C,ADC, temperature sensor and there are 21 GPIOs. This module core processor ESP32-C3 is a Wi-Fi+ BLE combination of system-level chips (SoC), designed for various applications such as internet of things (IoT), mobile devices, wearable electronics, smart home, etc.

You would then connect the signal pin from your Arduino to one of the signal pins on this module (for example, pin “HV1”), and then you would connect the desired signal pin on the module to the corresponding pin on this module (“LV1” if the higher voltage signal is connected to “HV1”).ĮSP-C3-32S is a Wi-Fi module developed by Ai-Thinker. Then, you would connnect the “LV” pin on the module to the 3.3V power source that is supplying power to the module and connect the “GND” pin near the “LV” pin to the 3.3V power supply’s ground. For example, if you were connecting your Arduino (5V signals) to a module (3.3V signals), you would connect the “HV” pin on the module to the 5V supply pin on your Arduino and the “GND” pin near the “HV” pin to the “GND” pin on your Arduino. Also connect the lower voltage source to pin “LV” and its ground to pin “GND” near the “LV” pin. Connect the higher voltage source to pin “HV” and its ground to pin “GND” near the “HV” pin. This module requires you to supply it with power from both the higher voltage level and the lower voltage level.

Import raspberry pi 3 part fritzing